|
Types of Floor Heating Systems Not one right way... many good ways Concrete Slab / Thin Slab / Subfloor Plates / Subfloor Board / Engineered Subfloor / Staple-up / Hanging Lowest temperature required = Highest temperature required = Concrete Slab Tubing or electric heating elements are attached to wire mesh or fixtures to hold them in place until the concrete floor is poured.
Building the subfloor this page shows how we are building the subfloor for the florida solar cracker house. The pictures below show liz preparing a shiplap joint on one of the.
home > Make Improvements > Floors & Flooring > Concrete Print page Bookmark Tell a friend Interior Concrete Floors Concrete overlays add color and texture Almost no shelter magazine is printed these days without some kind of interior concrete installation whether it is a sink, floor, or counter. Concrete is cool, clean, easy to live with, and very durable.
Advertise on this site Installing Tile Over A Wood Subfloor Concrete and Masonry, Flooring, Kitchens and Baths, Interior Published 10/19/2006 by Danny Lipford Installing tile over a wood subfloor is a lot easier today than it was when I started my remodeling career. The old-fashioned mud method — floating a thick mortar bed in preparation for the tile — has given way to using cement backerboard.
Our installation of the floating floor requires carpet, pad, and tack strip removal over a concrete subfloor. Approximately 500 square feet has been installed in this new home with the balance of the installation going over vinyl floor coverings in the kitchen and laundry areas. Wait!
There are three types of radiant floor heat: radiant air floors (air is the heat-carrying medium); electric radiant floors; and hot water (hydronic) radiant floors. All three types can be further subdivided by the type of installation: those that make use of the large thermal mass of a concrete slab floor or lightweight concrete over a wooden subfloor (these are called "wet" installations); and those in which the installer "sandwiches" the radiant floor tubing between two layers of plywood or attaches the tubing under the finished floor or subfloor (dry installations).
I'm not sure you want to put down a wood subfloor directly over concrete. Concrete does contain moisture and anytime you have wood in contact with concrete, there is a chance that moisture will be wicked up into the wood.
Solid wood and engineered flooring may be installed using a nail-down installation method. The flooring is attached to a tongue and groove plywood or wooden subfloor using nails or staples.
SuperStore Can I install an engineered floor over a concrete subfloor? The benefit of an engineered floor is that in most cases it can be installed directly over a concrete substrate that is clean, flat, dry and structurally sound.
Comments (12) I've seen it done in commercial restorations (concrete is a great way to level uneven subfloors). The only product I've seen here in the US is http://www.maxxon.com/product_detail.asp? ID=2.
Re: Installing wood subfloor on concrete slab [ Follow Ups ] [ Post Followup ] [ Flooring Discussion Board ] [ FAQ ] Posted by Dave Gobis on September 28, 19100 at 05:30:44: In Reply to: Re: Installing wood subfloor on concrete slab posted by Stephen Perrera on September 27, 19100 at 22:25:20: : : What would be the best method (and benefits) of putting wood subflooring (louan? , plywood?) on a concrete slab? Most likely covering would be ceramic tile.
Radiant Floor Heating on a Wood or Concrete Subfloor Tubing can be attached to a wood or concrete subfloor and a thin (2") gypsum cement poured over it. Uponor Radiant Floor Heating Manufacturer Gypsum cement is resistant to shrinking or cracking and is lighter than concrete.
Subfloor Before looking at the advantages of various wood floor types, wood species, finishes, it is extremely important to think about the subfloor. Subfloor defines installation methods avaliable to you.
Concrete was placed over plywood subfloor. Saw cut & stained 2
Draw a plan of the floor area on a sheet of graph paper, using one square per square foot of floor. Determine the number and length of 2 in. × 3 in.
hen preparing the concrete slab, the slab must be sound and flat. To prepare the slab grind off any high spots, fill low spots, clean up grease, oil and other contaminants, and sweep clean.
Q: Can new ceramic tile be installed over existing tile? Q: Can new ceramic tile be installed over existing vinyl? Q: Can new ceramic tile be installed over existing laminate? Q: Is it necessary to install underlayment or concrete backerboard over the wood subfloor for tile, marble and granite installations? Q: When installing tile over new concrete, how long should the concrete cure? Q: Can new laminate be installed over existing laminate? Q: Can new vinyl be installed over existing vinyl? Q: Is there a difference between vinyl and resilient flooring? Q: Is vinyl a good choice for high traffic areas? Q: I have a rather small bathroom floor.
Draw a plan of the floor area on a sheet of graph paper, using one square per square foot of floor. Determine the number and length of 2 in. × 3 in.
Checking for and avoiding excessive moisture in every subfloor must be done. Look around for visible water stains on the drywall and subfloor, particularly on the concrete.
Dear Concrete Subfloor, Many progressive doctors are recommending smooth surface floors for patients with asthma. You'll want to remove carpeting using the contractor worksheet SaferBuilding™ Demolition over Concrete Sub-floor ( SaferBuilding™ Demolition over Concrete Sub-floor ).
Every Substrate Presents Unique Challenges There are various challenges associated with the installation of hard surface coverings on concrete substrates. To begin, the coefficient of thermal expansion of concrete is close to twice that of ceramic tile.
There are three types of radiant floor heat: radiant air floors (air is the heat-carrying medium); electric radiant floors; and hot water (hydronic) radiant floors. All three types can be further subdivided by the type of installation: those that make use of the large thermal mass of a concrete slab floor or lightweight concrete over a wooden subfloor (these are called "wet" installations); and those in which the installer "sandwiches" the radiant floor tubing between two layers of plywood or attaches the tubing under the finished floor or subfloor (dry installations).
CLASSIC: 3/4" (19mm)thick. The MIRAGE Classic collection is designed for conventional installations, that is nailed or stapled down over a wood subfloor.
When installing a subfloor material of any kind, it's important to ensure you have a level surface. Leveling a subfloor, be it pre-existing or in new home construction, is the first thing you must do.
Information: General Construction Notes Contractor Requirements Coordination with Other Trades Special Application Conditions Contractor Requirements Clean: Floor must be broom clean with all blocking in place and holes filled. Other trades: Area to be poured must be free from other trades.
|
Laminate - Install the floor manufacturer’s foam underpad and laminate flooring on top of the DRIcore panels according to the floor manufacturer’s installation instructions. NOTE that the installation of a continuous vapour barrier on top of DRIcore is permitted as long as it is not sealed to the perimeter wall.
A typical basement floor is just concrete, which is a tough surface to work with. Need a wood subfloor to make that basement remodeling project easier?
APC CORK: Before installing your cork flooring, please check for moisture in your subfloor Look around for visible water stains on the drywall and subfloor, particularly on the concrete. If you do find their is moisture in your subfloor contact the adhesive manufacturer to determine best vapor barrier.
I'm not sure you want to put down a wood subfloor directly over concrete. Concrete does contain moisture and anytime you have wood in contact with concrete, there is a chance that moisture will be wicked up into the wood.
Re: Installing wood subfloor on concrete slab [ Follow Ups ] [ Post Followup ] [ Flooring Discussion Board ] [ FAQ ] Posted by Stephen Perrera on September 27, 19100 at 22:25:20: In Reply to: Installing wood subfloor on concrete slab posted by James on September 27, 19100 at 14:41:56: : What would be the best method (and benefits) of putting wood subflooring (louan? , plywood?) on a concrete slab? Most likely covering would be ceramic tile.
Ease of Implementation Easy to moderate. Initial Cost More than conventional plywood or OSB subflooring.
A New Solution for Subfloors Over Concrete DRIcore started in the mid-1990s when Bob Smith, a Longlac Wood Industries employee, had a basement moisture problem. To prevent future moisture and mold contamination in his home, Bob began researching for solutions to control moisture leaks in his basement.
Hardwood Flooring Over Concrete Slabs With the right subfloors, solid hardwood flooring can be installed successfully on either on-grade or above-grade slabs. Below-grade installation is not recommended for solid wood.
Above Subfloor - Wood strips or sleepers are glued and nailed to the subfloor. Tubes are placed between the sleepers.
A: This is a wood subfloor installed over an existing concrete subfloor without well ventilated air space below. Concrete on or below grade will have some moisture in it due to its proximity to the ground.
DRIcore - The Orlando location of the 2005 NextGen Home is an ideal setting to showcase the benefits of DRIcore®, the modular subfloor for use over concrete. Like most homes in the warm, humid south, the 2005 NextGen Home is to be built on a concrete slab.
Installing a hardwood floor over a concrete slab Even if your home was built on a concrete slab, you can still enjoy the beauty and charm of hardwood floors. Experienced professionals pay close attention to managing moisture and minimizing wood floor expansion and contraction when preparing to install hardwood floors on concrete slabs.
Dear NH, What is the best way to install a plywood subfloor over concrete slab? Regular or treated plywood? Glued or nailed?
Hardwood floors on concrete? Years ago there was only one way of doing so.
|
